Body
Hand-crafted fiberglass laminate; featuring layers of fiberglass on a gel coated surface and an inner core, providing high strength and superior surface quality. All high stress areas are reinforced with heavy woven roving, providing the strongest most durable and stable body in the industry.
There is no fiber glassing required, all inner liners and components, floor, fire wall, rear bulkhead, front wheel wells, doors, hood and trunk liners are fiber glassed in the molds with custom fixtures for precise and accurate placement. Our doors, hood, and trunk utilize a full inner liner system for strength and rigidity with a smooth finished look.
Doors, hood, top hatch and trunk come installed on the body using tapped sandwich plates behind their inner liners for strength and adjustability.
We mold our own bodies to exact outer dimensions using original specifications, our trunk tire well has been removed to allow a gas tank to be mounted in it’s place if using larger tires or IRS suspension and our firewall and front wheel wells changed to fit other than original front suspension. We’re utilizing our 27 years experience in the fiberglass industry which allows us to offer bodies in kevlar and kevlar carbon fiber. All bodies are molded and aligned so well that we remove all flash lines (lines formed from seams in molds) from the gel coat surface. All fiberglass components go through our 12 step total cure process, insuring no post cure and are inspected at each step of production. Every component is hand buffed to insure that the surface is even, flat and shiny. These features provide our customers with the highest quality and the shortest assembly time. |
|
Frame
Frame rails are reproduced from original profile under the main body including original body mount locations and mig and tig welded for superior strength and durability
102” wheel base
Main rails fabricated from 3/16” 2” x 4” and 2” x 3” box tubing
Frame is cross-braced with k member formed from 1” x 2” box tubing.
K member is designed for ease of routing exhaust, brake lines and fuel lines
Temporary front cross member
Rear cross member is constructed from 2” x 2” square tubing with 1 ¼” dia. threaded bar stock for mounting of coilover shocks
|
|
Triangulated Rear Suspension:
Triangulated four link arms setup for coilover shocks
Each four link arm has a single adjuster for fine tuning rear end location and adjusting of pinion angle.
Link arms are made from 1” diameter .156” heavy wall dom. Tubing with urethane bushings and a inner sleeve to accept 9/16” bolts.
All mounting brackets for attachment to frame and rear end housing are provided. |
$395.00 |
Following equipment installed on our frame
Including:
Frame
Rear Link Arm Setup
Rear Coilover Shocks
Front upper and lower stamped control arms
Strut rods and bushings
Manual rack and pinion steering with tie rod ends and bushings
Mustang II spindles and brake brackets
5 lug rotors, bearings and seals
Front calipers and pads
Front coil springs
Front shocks
9” ford rear housing with axles, bearings and seals
Non posi 9” center section
11” rear brake drums and loaded backing plates
Salvage yard tires
Above parts only (not installed) - Deduct $500
|
|
;){kind=link}